1 Cutter. 1 Sand Belt. Shape & Sand OM-CS-1C1B

SKU: OM-CS-1C1B Categorías: , ,



  • Designed for high production shaping and sanding of straight stock of solid wood, veneered panel and finish between coats with profile, angular, or straight edge.
  • Workpiece is through feed with rubber pad conveyor and spring-load pressure rolls at top, without sliding.
  • Extra slide side rolls extension table up to three feet for larger material supporting.
  • Sanding head can be adjusted forward & backward, up & down and tilt – 45 to + 90 degrees.
  • Variable sanding belt speeds 0 ~ 3600 RPM for the best finish result.
  • Automatic control jumping sanding head stroke design for not round over the front and end of material.
  • Variable feeding conveyor 10’ to 136’ to get different setup easily.
  • Sanding belt tension mechanism is self-balance designed, it maintains proper tension at all the time, that not only provides steady belt pressure but extends belt service life.
  • Constant sanding pressure is pneumatic cylinder controlled to achieve uniform and superior finish.
  • Air blower actives clean and cool down the sanding belt.
  • Industrial powerful shaper motor for best cutting capacity.
  • Shaper spindle can be adjust up & down, in & out with 9000-RPM speed.
Profile Platen Belt HeadWheel, Belt Head
Range of Workpiece Width2″ ~ 70″Brush Wheel Drive Motor2 HP
Minimum Length of Workpiece4″Brush Tilts+90° ~ 180°
Range of Workpiece Thickness1/6″ ~ 4″Sanding Belt3″ x 20″
Sanding Belt Width1″ ~ 4″Sanding Wheel Dia. Max8″
Sanding Belt Length98″Sanding Spindle Dia.1″
Belt Tilts-45° ~ +90°Spindle Speed0 ~ 3600 RPM
Belt Drive Motor2 HPShaper Head
Sanding Belt Speed0 ~ 2400 FPMShaper Motor7-1/2 HP
Profile Head Stroke0 ~ 3″Shaper Speed6000/8000 RPM
Sanding Pressure1 ~ 5 LBSShaper Spindle Dia.1-1/4″
Shaper Spindle Length6″
Max. Cutter Dia.8″